Dial Calibration Tester Suppliers in Chennai | 8754432261
Dial Calibration Tester Supplier in Chennai –Metric Measurement Technologies offering Customized Dial Calibration & Testing services to meet your requirements.
Dial Calibration Tester Supplier In Chennai – Metric Measurement Technologies in Chennai was established in 2007 a dial calibration tester in the Measuring Instruments and Gauges in Chennai. Over a period of 16 years Metric Measurement Technologies has established itself as a brand name in dimensional metrology through variety of products and services, through its own plants and its sister concerns to cater to the needs engineering industry for the Dimensional Quality Control requirements.
Feel free to contact us: +91 87544 32262, today for more information on our products and supply. Browse through our website and see what we offer our clients. We guarantee that our supply is of the best quality that can be found today.
Dial Test Indicator Calibration In Chennai
Purpose: The purpose of this procedure is to provide general instructions for the calibration of dial test indicators.
Scope : All standard dial test indicators used to measure, gage, test, inspect and control part compliance to customer specifications and drawings.
Procedure
- Preliminary Instructions and Notes
- Read this entire procedure before beginning the calibration.
- Calibration shall be performed in an environment that conforms to Manufacturer Specifications.
- The dial test indicator will hereafter be referred to as the Instrument Under Test (IUT).
- Verify that the IUT is clean.
- Visually examine the IUT for any condition that could cause errors in the calibration.
- An error in zero setting during calibration will be contained in every measurement and will increase in proportion to the distance from zero.
- If any of the requirements cannot be met, refer to the applicable manufacturer manual.
- If a malfunction occurs or a defect is observed while calibration is in progress, the calibration shall be discontinued and necessary corrective action taken; if corrective action affects a measurement function previously calibrated, the function shall be recalibrated before the remainder of the procedure implemented.
It’s based on Abbes’ principle and is used for calibration of Dial Gauges (Plunger & Lever type) and Bore Gauges. It has replaceable probe, so dedicated probe as master is not required.
- Calibration of Dial gauges (Plunger & Lever Type) and Bore Gauges
- Suitable for 0.01 and 0.001 mm (Least count 0.01 mm not covered in the scope of IS 2092)
- Interface with a computer for DG Cal Software
- Graphical presentation for errors in both directions
- Measuring Travel : 0-25 mm / 1 inch
- DCT 1 Repeatability : 0.0003 mm on Sylvac Display Unit with P25 probe
- DCT 2 Repeatability : 0.001 mm on Sylvac Dial
Give a Missed Call at +91 87544 32262 or Chat with us!
Why Choose Metric Measurement Technologies
Best Dial Calibration Tester Supplier over the Areas in Tamil Nadu
Trichy | Madurai | Puducherry | Coimbatore | Hosur | Sholinghur| Ranipet | Gummidipoondi | Vellore |
For More Visit our Location on Maps
